![]() The red light should go on continously for 10 seconds. ![]() Enter the new code (must be six digits) and then press the lock button again. Enter the digits "10" and press the lock button again. Enter your current code that you want to change (factory set is 12345) and then press the button that looks like a little lock on the keypad. The red LED will light on the front code side and beep twice to indicate you are in programming mode. You will see a small light and beside it is a small SET button by the batteries, it is labelled. Do not press a pen or anything into the small light, you do not need too. Snap off the back cover (opposite where you punch the numbers) by pinching the sides and pulling off. The jumper controls that for the appropriate installation. These locks are made to work on a door which, when you stand outside and face it, has its hinges on either the left-hand or right-hand side of the door (= door "handedness"). So if you are unable to view the file, download (for free) and install Adobe Reader first. That means that you need to have Adobe Reader or similar installed on your computer to view it. These instructions will work just fine for you: ![]() If the cap is mounted on Prongs 1 & 2, carefully remove it and move it over so that it mounts Prongs 2 & 3. On the right hand side under the batteries, you will notice that is says "Door Direction Jumper". "I have installed your Powerbolt, but when I push the Lock Button, it unlocks? What should I do?"įirst remove the cover on the inside of the Powerbolt unit. I have taken batteries out and reset few times with no success. SOURCE: kwikset smartcode deadbolt newly installed unlocks when lock button pushed.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |